Gallagher "The Billy" Energizer

A powerful 110v electric fence energizer used to keep in cattle, sheep, goats, horses, poultry and guard dogs. Effective at protecting against coyotes, stray dogs, bear and fox as well. It also works to keep out deer, raccoons and rabbits from garden/orchard areas.

• 7.0 Max stored joules
• 5.62 Max released joules* supplied by Gallagher
• 5.7 released joules in moist soil* in Premier's tests
• .9 released joules in dry soil* in Premier's tests
• Has performance indicator lights or digital displays
• Built in lightning protection
• RFI (Radio Frequency Interference) suppressed circuitry to reduce noise on radios and television
• Requires 17' of ground rod in the ground
• Draws 12 watts per hour
• Manufactured by Gallagher
• 4' cord
• 3 prong plug
• Will power approximately 3.5 miles of 5-7 strand fence, 32 rolls of 164' sheep/goat net and 15-16 rolls of 164' PoultyrNet. All distances are dependent on amount of grass/weed load on the fence

Low-impedance units work great with high weed/grass loads, but not as well with dry soils or poor conductors. This unit will work in both conditions. Safe to use with all polywires, polyropes, tapes and electrified nets.

The Billy can be mounted either inside or outside of a building, but not where there is risk of fire. The energizer must be mounted vertically. Protect the energizer from direct rainfall.

1. Connect insulated cable (stripped back 1 - 2" on ends) to the fence terminal on energizer, run the cable to the fence line and connect.
2. Then run a second length of cable from the ground terminal (with ends stripped again) on the energizer to the ground rod.
3. Secure to ground rod with a clamp.
4. Plug into outlet and test fence.

• WARNING: Powerful unit. Do not use on fences near children, visitors or the public.
• When working on the fence, make sure the energizer is unplugged before working on the fence or the energizer.

To test the energizer:

1. Turn off energizer.
2. Disconnect ground wire and the fence wire.
3. Plug energizer back in.
4. With fence tester, put the ground probe to the ground terminal on the energizer and the metal loop at the top of the tester to the fence/positive terminal. The reading you get tells you how well the energizer is working without any other variables. If there is a very low voltage (under 4000v) or no voltage, then the energizer may have a problem. If the voltage is high (greater than 4000v) then the trouble lies with your fence. Most energizers put out between 5000v and 8000v when there is no load (i.e. no fence hooked up).

Our unique 2-Year Warranty--
If an energizer fails within 2 years from the purchase, Premier will replace the module/unit at our cost (unless the reason for its failure is customer abuse or neglect). Your credit card will be charged for the replacement but you will receive full credit when the failed item is back at Premier. Your only cost is shipping the failed item to us. If the original energizer is over 2 years old, we will repair and/or replace it, but you pay for the repair cost and freight.