PI 21n Notched Terminal Insulator
For insulating low-tension fences at corner and end posts and around trees. Notch eliminates need to thread strand of cable or twine through insulator.
How to install a PI 21n Notched Terminal Insulator
|How to Use||
If using this insulator for rope or MaxiShock, a P Spring (sold separately, see accessories tab above) can be tied directly to the insulator prior to fence wire being attached to P spring using rope or wire.
When the fence wire is pulled tight, this insulator will pull away from the post.
It is sometimes difficult to get large rope through the notch. To help this, just twist the rope backwards and it will slide in.
You must be logged in to leave a review. Please log in.
It is difficult to explain but because of the way that the wire must go into the insulator (horizontal as shown in the picture) the part that attaches to the post is extremely awkward, at best.
You have two options, loop it through the given hole which is vertical which causes the insulator to twist, or you have to loop it through the horizontal open hole furthest away from the post. That can cause the insulator to flip down which can pop the wire out and in my cause caused a gate handle to pop out, releasing my goats.
I might recommend pairing these with zipties to hold them firmly in place.