Energizer and Charger Kits for Poultry Fence
Who should consider an energizer kit?
New users tell us that netting and energizer kits simplify their purchasing decisions—because there are many netting options, support post choices, energizers, ground rods, etc., and because it’s complicated for those without experience to buy components and build fences.
We also know that:
- Many already own an energizer. If you're not sure whether it will work for our fences, call us.
- Many need longer fences and larger energizers than suggested in our kits. If so, call us and we will help you reach a solution.
- Sometimes seeing helps. Watch our "How-to" videos to see how to properly install and take down netting.
Note: Do not use an energizer that is labeled high impedance, continuous current, weed burner or weed chopper. We recommend only low or wide impedance energizers.
Continuous current (high impedance) energizers have a pulse type that is long (in time) but low in energy. Low impedance have pulses that are very short (in time) but higher in energy. The long duration continuous current pulses create a spark that is also long in duration—long enough for it to set fire to grass/weeds/leaves/needles that might touch the fence. In our opinion they should never be used on any fence for this reason. They must not be used on electroplastic fences (can melt the plastic). Low impedance pulses are so short (3/10,000 of a second maximum) in time that heat build up is less likely.
To Reduce Risk and Liability...
Are electric fences a serious safety risk to humans?
Because touching an electric fence is painful and the voltages are high, most assume that the risks from an energized fence must also be high. That’s a myth. Consider that millions of people throughout the world are "exposed" to millions of electric fences every day—yet they are involved in (but are not always the cause of) less than one human death or serious injury per year worldwide. Compare that to the number of annual injuries and deaths that occur from human exposure to tractors, skid loaders, ladders, PTO shafts, balers, mowers, combines, bulls, stallions, rifles, shotguns, knives, etc. This is not to suggest that there is no risk at all. There is, indeed, a small level of risk. And with risk, there is also liability to the fence’s owner.
What NOT to do!
- Never place your head or upper spine near an electrified wire. Accidental head or neck contact can occur when pushing a voltage probe into the soil. Be careful when doing so to avoid head-to-wire contact!
- Never attempt to step over or climb through an energized fence of any kind.
- Never encourage anyone to touch an electric fence.
In 1991 an accidental fatality occurred when a young child’s head contacted an electrified fence while the child was crawling on wet grass. The fence was correctly installed and functioning properly. The energizer was a UL approved unit. As a result, Premier strongly advises against allowing toddlers access to any electrified fences. Also, due to this incident and others, experts now suggest that human contact by an energized wire to the head and neck may be the most dangerous point of contact. We urge all to especially avoid this kind of contact.