Activator Kit with #380000 Insulator
- Attach the insulator onto post. If connecting to a T post, fit the insulator over the T post stud. Snap into place.
- To connect the electrical flow to the activator and gate, attach a piece of insulated wire (sold separately) from the fence to the split-bolt-joint clamp on activator. (Loosen nut from joint clamp, shed off approximately 2" of insulation from the insulated wire, and then slip the bare wire into slot of joint clamp. Tighten nut.) A SafeHandle (sold separately) will hook into the open hole on metal bar of activator.
- When the handle is connected, the gate is energized. When the handle is not connected, the gate is not energized.
- If the fence is continuing on from the gate, use insulated wire under the gate to feed the other side of the fence.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Posts and AccessoriesItem #327600 -
For end, corner and curve posts for temporary and semi-permanent fences. Excellent line posts because they ground uninsulated wires and without causing rust. (Rust from painted T posts will cause high-carbon HT wire to rust much faster.)$12.90