Premier 4000c Clipping Machine
- Slick shearing show sheep
- Clipping meat and dairy goats
- Shaving or peeling beef & dairy cattle
- Clipping llamas and alpacas
- Clipping horses
- Clipping show pigs
- Clipping ranch dogs
- They've also been used to cut imitation turf
Use with our large blade sets.
- 110 volt.
- Quieter. Less motor "whine", kind to your ears and less likely to upset animals.
- Permanent rare-earth magnet motor enable more torque (power) and require less space and weight than ordinary motors. Less heat is produced by the permanent magnet motor and the fan forces air forward through our heads—so the heads run 20° F cooler.
- Up to 20% shorter in length than other motors.
- Weighs up to 15% less than other motors.
- Smaller grip than other motors.
- Sleek, low-profile ribs makes it easier to grip the tension knob.
- Shorter tension bolt equals fewer turns needed to reset tension, so you spend less time changing and tensioning blades.
- Internal roller bearings instead of bushings (less heat, less wear and greater longevity).
- Stainless steel inserts that are riveted in reduce the possibility of the inserts becoming loose.
- Round steel drive in place of a plastic bushing makes fitting the top blade easier.
- Includes 2 screws for attaching to motor.
- Motor has a 16 ft electrical cord.
- Only 3 minutes to change a clipper head to shear head.
- Will drive Premier and Lister® clipper blades.
- Rarely slows down under load.
- Plows through fiber. Drives shear head with equal power.
- Motor is smaller in size, lighter in weight and shorter in length than any other large clipper.
Failure to oil as often as recommended may lead to excess heat and premature wear and tear.
Warning: Unlike some other clipper motors, this motor will neither slow down nor sound different when oil is needed. But failure to oil will quickly cause damage to the blades and drive head. So you MUST apply oil by time instead of sound. Apply a small amount of oil every 3 minutes to the tips of the teeth and each side of the blade by dipping them into a dish of oil or pouring oil directly onto the teeth with a small oil container and every 10 minutes drip oil into the small hole behind the tension knob assembly. Excessive wear can occur if not oiled properly!
Warning: Risk of electrical shock—Connect only to a branch circuit protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the circuit is protected by a GFCI.
Write a Review
You must be logged in to leave a review. Please sign in.
My horse trainer had these clippers and we did the clipping of horses together. I moved away and now have to clip my own horse. I had two choices. I could buy one clip job by someone else. The second choice, I could buy these clippers. I chose to buy these absolutely amazing clippers. These clippers could probably mow your lawn in the shortest amount of time you could imagine. The clippers leave your horse clean and sleek, minus all the crazy lines that alot of clippers leave. I was worried about the torque that you need to screw the blades on. I watched the video and was at ease with my performance to make my clippers run correctly. I oiled the specific points as suggested at the instructed time intervals. I never thought the clippers were overheating. The hair just came off so easy and in so little time. They are easy to clean and maintain well worth the money. I do recommend you get ear plugs if you will be doing the clipping, they are loud but given the performance of the clipping speed it's worth buying two sponge ear plugs. I will probably clip my horse a couple of times this season. I will have then saved money by buying these clippers. Quite a few people have commented on the lack of mower lines my horse has. I did scrub my horse prior to the clipping. This is very important to have the results that I had from these clippers. I highly recommend these clippers to all the equine people out there.
Yes! We sheared 4 lambs for the first time ever and it went great. Followed all directions to a T!
I have been clipping goats today and absolutely love these clippers! They are wonderful. Very easy to use and you don't have to go over areas multiple times. The staff was great to answer my questions and helped me get what I needed. Thank you,
Eva S from Idaho
So far we have been really pleased with these clippers. They do a nice job and are really easy to use with no danger of cutting the lambs skin. They are light weight and the blades are very easy tot put on and take off. They cut nice and short with the fine blade and leave a nice smooth finish with no blade makers on the lamb. They are very easy for kids to use too I am hoping they last a long time!
Brad G from MIssouri
Good clippers. They are louder and longer than the set of Wahl clippers we have. The length makes them harder to use on smaller sheep and goats. However, the motor runs cool and due to the smaller diameter they are easier for my daughter to hold.