- Stainless steel bolt
- 1 1/4" long
- 3/4" wide
- Plated steel
How to Use
- Loosen screw in the middle of connector.
- Slide ends of both ropes to be connected into connector, one on top and the other on the bottom.
- Re-tighten screw with a screwdriver.
Write a Review
You must be logged in to leave a review. Please sign in.
Fred K from NY State/Hudson Valley
This is a good product and I recommend it. I use these with Intellirope PE 6.0 at end points with p-springs, and even for in-line splicing, and have no trouble at all with slippage or "halves spinning" as some other customers have mentioned. Simply employ a little common sense and install them as recommended and you'll have no trouble.
Charles E from NY State
These connectors are awful. I tried to use them on the 6.0 mm Endurasoft rope and they would not hold it. The two halves spun around and would not grip. I have used better ones from Tractor Supply that were about 2" long and had a channel big enough to hold the rope securely.
Easier if 2 people attach the 2 ropes together. I was all thumbs.