Sign up for Premier1's Newsletter

Udderly EZ™ Milker

Makes obtaining colostrum from a difficult ewe or doe less of an "athletic event".

A few pumps creates a seal allowing the teat valve to open and release milk. The flow is not rapid, but effective.

   

ITEM # DESCRIPTION AVAIL. WEIGHT PRICE QTY
556111 Udderly EZ™ Milker Kit (for sheep & goats) with 1-16 oz bottle and 2-8 oz. bottles In Stock 1.50 $191.00
556112 Replacement quart (32 oz) bottles - 2 pack In Stock 0.50 $15.00
556113 Bottle Connector for Udderly Ez In Stock 0.05 $9.60
556114 Replacement pint (16 oz) bottles - 2 pack In Stock 0.50 $10.65
556115 #1 Small (Pygmy/Shetland) insert In Stock 0.50 $23.45
556116 #2 Large (sheep/goat) insert In Stock 0.50 $23.45
556121 Replacement 8 oz bottle - 1 ea In Stock 0.20 $2.19

Click Below to View Instructions/Diagrams

Udderly EZ Milker Info [2 MB]

Unable to view
the files at left?

A PDF viewer is required for viewing and printing. Click the icon below to download the FREE Adobe Reader.
Common Uses

Use for collecting colostrum and milk from ewes & does.

Specs

Kit includes:
• Milker
• 1-16 oz bottle & 2-8 oz bottles
• EZ Wipes
• Instructional CD

Tips

  • Wait up to 30 seconds for the ewe to relax enough to release milk.
  • Once suction has been obtained, "bump" the milker into the udder - similar to the motion a lamb would make if nursing.
  • When suction is obtained - try positioning the milker from various angles (also apply the "bump" concept while doing this).
  • Try a few more squeezes than is advised if milk flow slows.

For animals with small teats: The package with rubber inserts (#556111) is needed or you can purchase inserts individually (#556115 or #556116). For goats order quart bottles (#556112).

How to use

ATTENTION!! Our new Silicone Inserts, (Liners) have arrived!!

Please read this Product information thoroughly.

At EZ Animal Products we are continually listening to our customers and are always trying to upgrade the Udderly EZ Milkers.We have found better Silicone Inserts to go into the #2 (large) extraction tube.

The top part of the Silicone Insert is flared at the point where it goes into the top of the hard plastic tube. This virtually eliminates any air leakage from around the top of the tube. (And is easier to assemble) Both the large and small Silicone Inserts fit into the same #2 Tube. (They will not fit into the #1 Tube) We are still including the #1 Tube into each kit because in some instances you may want to use it without an insert. Besides one being bigger than the other, each hard plastic tube is embossed with the number on the front of it.

Please Note: When inserting the large Silicone Liner into the #2 Tube, once you have it seated, you will notice that the top of it is still a little above the top lip of the extractor tube. Just push it down and it will seat around the top of the extractor tube. We will show this in the instructional video that we are working on at the present

It is still possible to milk most any animal without the inserts but they stop the possibility of any milk/colostrum from getting drawn into the pump.

REMEMBER!! Both Silicone Inserts now fit into only the #2 hard Plastic Extractor Tube.

Thank you for using our products.

The Udderly EZ Team.

Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Item # 563000 - In Stock
$1.70
Most proven screw-on teat. Closest in size, shape and texture to the "real thing" so orphans prefer it.
Item # 562900 - In Stock
$4.80
An excellent plastic bottle specially designed for the rigors of lamb & kid feeding.
Item # 981005 - In Stock
$30.00
Edited by Burns, Guare & Perkins.
Average Rating: 4 out of 5
Number of Reviews: 4 customers reviewed this product.

Write a Review

Date: August 10, 2014
K S from Wyoming
Would you recommend this product? No
I am writing this review based on usage of this product for our cow instead of sheep/goats because the pump is the same for all species.

We purchased and used two Udderly EZ milkers for our milk cow. We bought two thinking we could use them both at the same time and cut down the time it takes to milk. This did work for a couple months before the problems started. We just kept having parts break. The little rubber valves don't last too long and are expensive to replace. Both our handles broke within a short amount of time. These are also expensive to replace. The bottle clip on one broke, so we went down to using one pump with the working bottle clip. Then, the back part of the pump blew out. It was only connected by flimsy plastic clips and these just wore down and finally snapped off. So I duct taped the back of the pump on and this worked ok. Kept having to replace the duct tape though as it would lose tightness after a few washings. Then it got to the point where I could not tape it on tight enough to create the vacuum. We started using the other pump and the same thing happened to it. Now the whole setup is basically worthless as I am not forking over another $100 to replace the pump. This all happened within 4-6 months.

I think these are neat little milkers, but probably should be used more for backup milking if power is out, or colostrum collection only. Their website states these milkers can be used for daily milking, but we have not found this to be the case. We could have bought a small bucket milker for the money we have put into the Udderly EZ. Would not recommend for daily milking. Oddly enough, I was most worried about having to replace bottles. We only lost one bottle during those 4-6 months. The bottles do seem to hold up well but are useless without the rest of the assembly.
Date: April 30, 2014
Bruce/barbara K from WY
Would you recommend this product? Yes
I use the milker to milk out a ewe or get colostrum when I do not want to upset them. They usually do not fight the milker. However, it is quite a lot slower than hand milking. My husband never uses it for this reason.
The bottle clip is not durable and seems to get more brittle with age. I find the bottles hard to clean, and the bottle cap liners and bottle seals are not ideal.
Works fairly well but pricey for occasional use.
Date: January 28, 2013
Larry B from MN
Would you recommend this product? Yes
The Udderly EZ Milker is a great tool for collecting colostrum if time is important to you and if you do not want to be frustrated by ewes who do not want to be milked out by hand.

The Udderly EZ Milker could be built to be more durable. The clip that holds the bottle breaks more easily than ideal--especilly if cold. However, I would not be without one.
Date: August 4, 2011
Davilyn E from California
Would you recommend this product? Yes
I bought this last month and its the best money I ever spent. I can milk each mini-oberhasli goat in less than five minutes. They are more relaxed than with hand milking. I can be sure I am getting the last little bit out so they don't get mastitis.
Easy to clean.
Date: March 22, 2011
Katie W from Colorado
Would you recommend this product? Yes
I am not sure how I went all of these years without this product! It is GREAT. It was easy to use and fast. It didn't appear to cause the ewe any discomfort and in no time I had 8 oz. of colostrum. I was able to come back a few hours later and get another 8 oz.

With the price of lambs at an all time high, saving just one pays for this handy item.
Date: January 13, 2011
Earl L from Pennsylvania
Would you recommend this product? Yes
I recieved the Udderly EZ milker last week
and just got to use it this week. It appears to be a high quality unit. It takes a little bit of practice to get familiar with using this product. More familiarization that anything else. I have used it 3 times and this time was very easy and I collected a whole bottle of colostrum in a couple of minutes. The
hardest thing is restraining the ewe while milking her. I used to get a couple of ounces milking them by hand and this product is much better. I am very happy so far.