Premier 4000c Clipping Machine

Clipper head uses include: clipping meat goats, dairy goats, cattle, and pigs for show, slick shearing lambs, body clipping horses, clipping llamas and alpacas and making outdoor dogs cooler & more comfortable in the summer. They've also been used on imitation turf!

• Quiet- less motor "whine" is kinder to your ears and less likely to upset animals.
• Permanent rare-earth magnet motors enable more torque (power) and require less space and weight than ordinary motors.
• Less heat is produced by the permanent magnet motor and the fan forces air forward through our heads- so the heads run 20 degrees F cooler.
• Up to 20% shorter in length than other motors.
• Weighs up to 15% less than other motors.
• 15% smaller grip than other motors.
• Sleek, low-profile ribs makes it easier to grip the tension knob.
• Shorter tension bolt equals fewer turns needed to reset tension, so you spend less time changing and tensioning blades.
• Internal roller bearings instead of sleeve bushings create less heat so they last longer.
• Stainless steel inserts that are riveted in reduce the possibility of the inserts becoming loose.
• Round Steel drive in place of a plastic bushing makes fitting the top blade easier.
• Includes 2 screws for attaching to motor.
• Requires a screwdriver and about 3 minutes to change heads.
• Will drive Premier and Lister clipper blades.

Lighter, quieter and easier to handle than other machines.

See PDF above for tensioning and oiling instructions.

We are no longer converting machines to 220v.

Failure to oil as often as recommended may lead to excess heat and premature wear and tear.

Warning: Unlike some other clipper motors, this motor will neither slow down nor sound different when oil is needed. But failure to oil will quickly cause damage to the blades and drive head. So you MUST apply oil by time instead of sound. Apply a small amount of oil every 3 minutes to the tips of the teeth and each side of the blade by dipping them into a dish of oil or pouring oil directly onto the teeth with a small oil container and every 10 minutes drip oil into the small hole behind the tension knob assembly. Excessive wear can occur if not oiled properly!

Covers all labor and parts for 3 years from the date of purchase. With the exceptions of abuse (i.e. dropping it) and neglect (failure to oil frequently enough).