Author: Gordon
Date: 06-12-15 18:24
Here are the directions. We don't have a video at this time, but if you have any questions I can walk you through it.
If a horizontal wire is broken—
1. Disconnect from power source.
2. Cut out the bad portion of the horizontal wire with a pair of scissors.
3. Measure out an appropriate amount of the replacement conductive or non-conductive material.
4. Tie the replacement material to one side of the break with a square knot. (If possible, twist the metal filaments together of the original material and the splicing material before the knot is made.)
5. Repeat the twisting, tying and knot step on the remaining side of the break.
6. Place a brass ferrule over each of the square knots and clamp together with a pair of pliers.
Thank you,
Gordon (1-800-282-6631)
|
|