Manual Joint Clamp
Product Details
For making electrical connections to and from 12.5 gauge high-tensile (HT) wire.
- Reliable
- Easy to use and readjust
- One clamp can connect up to 4 wires
Specs
- 1-1/4"L x 1"W x 1"H
- Non-corrosive metal
How to Use
- Remove nut and washer. Place split-bolt portion over the wire that is being attached.
- Place bare end of connecting wire into the slot of split bolt. (If using insulated wire, thread off about 2" of insulation.) Repeat as many times as needed for multiple wires.
- Replace the washer; screw the nut down tight. Do not over-tighten.
Precautions
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
-
Energizer Solar Panels and Accessories
MaxiShock Double Insulated Cable, 25'
Item #164205 -Electric fence cable with thick layers of insulating for transporting high voltage pulses from the energizer to the fence line.
$10.00 -
High-Tensile Accessories
Compression Spring
Item #344000 -Use compression springs for shorter runs of high-tensile wire and around feedlots and corrals that receive frequent animal impact.
$8.50 -
High-Tensile Accessories
Wire Twister
Item #408300 -Use this tool to twist wire and terminate the fence line. Can be used with high-tensile and woven wire.
$1.80 -
High-Tensile Accessories
Knipex High-Tensile Wire Cutters
Item #406002 -While clippers for 12.5 gauge and other high tensile fence wires. Works well for soft wire too.
$65.00 -
High-Tensile Accessories
Multi-purpose Fence Tool
Item #408301 -Hammer, hold staples, remove staples, grip or cut wire, an essential tool in every fence builder's kit.
$10.20
Write a Review
You must be logged in to leave a review. Please sign in.
Danny E from Washington
Easy to use.
Michael O from Missouri
I use these sparingly only because they tend to loosen up over time. They are a fine product, but I’ve just noticed that for long term connections, they can loosen up too much. I think it’s the vibration from the wind going across the wires, or something like that.
Darrel D from South Dakota
Premier has a lot of great products and I will remain a Premier customer but the threads on these joint clamps are difficult to get nut started and seem to break easy if tightened just a little too much. I have started using Dare brand manual joint clamps and will see if both hold up similar over time.
Randy A from Alaska
Great product. Perfect for 12.5 gauge HT wire. Price is right.
Mary R from Kentucky
Perfect for hi tensile connections. Easy to use. Can be finger tight for quick release if you need it.