- Easy to use
- Easy to readjust
How to Use
- Remove nut and washer. Place split-bolt portion over the wire that is being attached.
- Place bare end of connecting wire into the slot of split bolt. (If using insulated wire, sold separately, thread off about 2" of insulation.) Repeat as many times as needed for multiple wires.
- Replace the washer; screw the nut down tight. Do not over-tighten.
Write a Review
You must be logged in to leave a review. Please sign in.
Mary R from Kentucky
Perfect for hi tensile connections. Easy to use. Can be finger tight for quick release if you need it.
Lloyd M from NC
Bigger than I expected, and a bit too heavy for my intended use linking non-HT wires. Probably ideal for the recommended use of linking 12.5 gauge HT wire