Replacement - Electrical clip for netting
This clip is designed to connect all the horizontals on any electrified netting together electrically.
- Stainless steel
- 1-1/4"L x 11/16"W
- To use, gather the conductors at the end of the net and slight twist into one tight group.
- With pliers, crimp the clip over the conductors. The connection must be tight and secure to keep it from falling apart or becoming loose.
Listed below are recommended optional components. Your particular situation may require alternative recommendations. Please call and talk to our fence consultants if there are any questions at 800-282-6631.
ElectroNet® 9/35/12, (164' x 35" white/black roll), single spikeItem #201000 -
A portable electric fence that is 35" tall installed. When properly energized, it’s a nearly impenetrable mesh to sheep, goats, coyotes and dogs.$135.00
Write a Review
You must be logged in to leave a review. Please sign in.
Chris A from South Carolina
These little clips are perfect for making "jumper harnesses" (using a piece of stranded wire) for polywire. I have a permanent perimeter fence with a single strand of polywire inside. Then I run temporary cross fencing. I needed a better way to temporarily connect the temporary polywire to the permanent, without damaging either. They seem to be secure, make a good electrical connection, and can be removed without damaing anything.
Raul P from Texas
Although I haven't had to use it, its light, inexpensive and sure to work when needed.