SnapOn Harp Clip Tool
Product Details
Install Snap-On Harp Clips faster and with less effort using this simple, handheld tool. Designed to reduce hand strain and ensure a secure fit every time.
- Speeds up installation
- Reduces hand fatigue during repetitive setup
- Zinc-plated for rust resistance
Specs
- Dimensions: 2.25"L x 1.75"W
Installation
- Hold the jaws of the SnapOn Harp Clip at an angle against the post. With your other hand, position the C-shaped opening of the tool over the top and bottom jaws of the clip.
- Twist the tool to spread the jaws and snap the clip onto the post. Both ends will snap on at the same time.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
-
Insulators
SnapOn Harp Clip, 3/8", each
Item #325310 -For attaching low-tension wire on 3/8" fiberglass posts. “Harp” design allows conductors to slip easily into the loop while preventing them from slipping out.
$0.40 -
Posts and Accessories
Step-In FiberRods, 3 ft
Item #321834 -A 3/8" dia. fiberglass fence post well-suited for rotational grazing. Features a protective polyester veil for longer life and less splintering.
$3.25 -
Posts and Accessories
FiberRod Post Driver
Item #321880 -Hand-held post pounder to help drive fiberglass poles into the ground. Steel pipe construction with welded handle fits posts from 3/8" dia. up to 1/2".
$9.00 -
Posts and Accessories
SmoothCote™ FiberRod Posts, 4 ft (3/8" dia), each
Item #321841 -Lightweight fiberglass posts for use with livestock containment fence or deer deterrent fence.
$2.10 -
Posts and Accessories
Drive Cap for 3/8" posts, each
Item #321810 -Place over the top of fiberglass rods prior to insertion. Nylon cap reduces damage and increases the lifespan of the post.
$0.61 -
Fence Connectors and Accessories
Dead Blow Hammer, orange
Item #205015 -Versatile hammer delivers a controlled impact with minimal vibration and rebound.
$11.00 -
Fencing
Warning Sign
Item #346000 -Let passersby know that your fences are electrified with this easy-to-read electric fence warning sign.
$2.50
Write a Review
You must be logged in to leave a review. Please sign in.
Robert P from North Carolina
Since the tool wasn’t that expensive, I went ahead and bought two, expecting to lose one of them.
The first 100 clips I had to put on it were easier to use my bare hands. After that, the clips got quite difficult. This tool proved to be very helpful after my hands fatigued. I’m right-hand dominant. I place the clip on the pole with my left hand facing left on the pole, then twist the clip on with the tool using my right hand.
Karenlynn R from Washington
Might work? I couldn’t get it situated and used my hands instead.
Annika O from Virginia
I ordered this because snapping on the clips is hard on your fingers and hands. However, it turns out it is easier to use your hands than this tool. The dimensions don’t seem to quite fit—the prongs aren’t quite wide enough apart to slide the tool over the jaws of the clip. A redesign would be good.
Lawrence K from Wisconsin
They recommend having these and they're right... my hands are no longer strong enough. It takes a while to learn how to use it to the best advantage.
Ellis R from New Hampshire
It was easier to snap the harp clip on and off by hand than by using this tool. Don't waste your money on it.