Wire Panel Connector Hinge
- Big Bale Feeders
- Lambing pens
- WirePanel gates
- 9 gauge wire.
- Our 48" and 36" hinges are now 25% larger in diameter so they can more easily twist around two 3/8" rods.
- Stainless steel.
How to Use
- Start at top of where two or 3 panels meet.
- Turn hinge so it screws down.
- Twist all the way down to keep the end from sticking out.
- Make sure the top is screwed all the way down.
- Point the very top to the outside of the pen.
- Make sure to catch all sections of the panels on the way down.
Write a Review
You must be logged in to leave a review. Please sign in.
Julie F from Oklahoma
These are amazing! Bought four to try them out. They are so incredibly easy to use I have all different kinds of panels - cattle, hog, 4x4, 2x4, and the hinges worked for all of them - even joining unlike panels - just had to help guide a little. So quick to attach or unattach. Much better than cutting wire pieces to attach panels. Quality is fantastic! Ordering more today!
Doni P from North Carolina
What a great product. I bought 5 of these hinges for the Big Bale Feeder and they work great. I can imagine many other uses for these!
Gerald L from Indiana
Very happy with the product. Went looking for an easier way to make a gate from cattle panels and found this product. Easy to install, strong, and even easier to use once installed. If you are look to install an affordable gate or just connect panels to create a knock down fence/temp kennel this is the product.
These are the best way to easily connect panels. Using 8 foot panels allows me to fold 2 with the hinge, move and easily set up again. My goats do climb up to lean on my panels. Zip ties break under the weight and wire tying takes so much longer. These hinges can be used again and again. No more roles of tie wire! I used to spend hours moving panels around. Now this lady gets it done fast without the backache. It always seems like I could use a few more. My orders have always arrived quickly. The cardboard tube they were shipped in just needed a small cut in one end to make the hinges slide out.
Joseph M from Missouri
In May I purchased 16 48" and 20 36" units to make tomato and pepper cages with 4ga cattle panel material. When I went to make the cages I discovered that the diameter was way too large (made for loose, sloppy corners). I now see that they mention that the connectors are now sized for 3/8" rods (.375") versus 4ga (.2"). So my purchase turned out to be a total waste. I would never purchase these again. In the video I guess that the old style connectors are being used (seem to fit quite nicely with regular cattle panels. I guess that I have more for the scrap heap now ($100 down the drain).