Wood Line Power Driver
Allows use of a power drill to rapidly screw Wood Line Post insulators in and out of a wood posts. Pays for itself if you install or remove many insulators.
Use with Wood Line Post insulators.
California Residents: Proposition 65 Information
Specs
- Shaft: 1-1/4"L
- Cup: 1" deep
- Galvanized steel
How to Use
- Put bit end of power driver into chuck of drill and tighten.
- Insert the Wood Line Post insulators into cup of driver, lining up slot in jaws of insulator with pin inside cup.
- Give a half-turn to lock the insulator into driver.
- Screw insulator completely into post.
- Give a half-turn in the opposite direction to release insulator from driver.
- Thread conductor through insulator.
- Predrill holes in the wood post.
- Put bit end of Wood Line Power Driver into chuck of drill and tighten.
- Place power driver over the insulator line up with pin inside cup of driver.
- Insert the screw tip of insulator into the predrilled hole.
- Thread conductor through insulator.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
-
Insulators
Wood Line Post Insulator, white, each
Item #380711 -For attaching low-tension conductors to wood line posts. Alternative to the common ring insulator. Wide, deep threads stay in wood posts well.
$0.37 -
Fence Connectors and Accessories
P Spring
Item #255010 -Used to keep rope fences at desired tension. Install a P Spring every 1320 ft.
$3.10 -
Conductors - Rope-Twine-Wire-Tape
IntelliRope® PE 6.0, 660 ft. roll
Item #256900 -6mm (1/4") dia. electrifiable rope for permanent or temporary fences. Polyethylene filaments resist wear and abrasion. An effective anti-deer conductor.
$59.00 -
Fence Connectors and Accessories
RopeLink 2.6 (for 6mm rope)
Item #256210 -For splicing or terminating 4.5mm and 6.0mm fence conductors. A fast, yet secure connection.
$0.82 -
Fence Connectors and Accessories
Fence & Battery Digital Tester
Item #200010 -All-in-one fence tester checks the voltage of energizers, fences and 12V batteries. Simplify electric fence troubleshooting with one device!
$24.00 -
Fence Connectors and Accessories
PowerLink™ 4.0, 30" long
Item #335500 -Make instant, in-field connections between electric fences without turning off the energizer. Simple to use and effective.
$5.00 -
Fencing
Warning Sign
Item #346000 -Let passersby know that your fences are electrified with this easy-to-read electric fence warning sign.
$1.60
Write a Review
You must be logged in to leave a review. Please sign in.
Robert L from South Dakota
I used it with an impact driver and it broke after 27 insulators. That being said it does what it is supposed to do. Probably should use a drill instead of an impact driver. I welded it back up, we will see how it holds up 2nd go-round. Way better then screwing them in by hand.
Mitchel G from Ohio
This is a very convenient product—I can't imagine trying to put in any number of insulators without it! However, I would recommend that two little notches or indentations be put on the barrel of the driver to mark when the insulator is upright. That would save time. I marked mine with a permanent marker which worked great except that it rubbed off a few times.