Rope Connector 1.0
- 1-1/4"L x 3/4"W
- Plated steel and stainless steel bolt
How to Use
- Loosen screw in the middle of connector.
- Slide ends of both ropes to be connected into connector, one on top and the other on the bottom.
- Re-tighten screw with a screwdriver.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Valerie T from North Carolina
Work great! I had a blonde moment to start, thinking I had to strip the wires away and couldn't get it to grip, but once I realized the entire piece of rope gets secured, all went well.
Tamara W from Illinois
Easy to use. I was able to put up fencing alone using these. Made sure to unscrew them first so they were ready to go as I was installing. Used with the Intellibraid 6.0. Thanks for a great product!
easy to use.
Fred K from NY State/Hudson Valley
This is a good product and I recommend it. I use these with Intellirope PE 6.0 at end points with p-springs, and even for in-line splicing, and have no trouble at all with slippage or "halves spinning" as some other customers have mentioned. Simply employ a little common sense and install them as recommended and you'll have no trouble.
Charles E from NY State
These connectors are awful. I tried to use them on the 6.0 mm Endurasoft rope and they would not hold it. The two halves spun around and would not grip. I have used better ones from Tractor Supply that were about 2" long and had a channel big enough to hold the rope securely.