Wire Panel Connector Hinge
- Big Bale Feeders
- Lambing pens
- WirePanel gates
- 9 gauge wire.
- Our 48" and 36" hinges are now 25% larger in diameter so they can more easily twist around two 3/8" rods.
- Stainless steel.
How to Use
- Start at top of where two or 3 panels meet.
- Turn hinge so it screws down.
- Twist all the way down to keep the end from sticking out.
- Make sure the top is screwed all the way down.
- Point the very top to the outside of the pen.
- Make sure to catch all sections of the panels on the way down.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Gerald L from Indiana
Very happy with the product. Went looking for an easier way to make a gate from cattle panels and found this product. Easy to install, strong, and even easier to use once installed. If you are look to install an affordable gate or just connect panels to create a knock down fence/temp kennel this is the product.
These are the best way to easily connect panels. Using 8 foot panels allows me to fold 2 with the hinge, move and easily set up again. My goats do climb up to lean on my panels. Zip ties break under the weight and wire tying takes so much longer. These hinges can be used again and again. No more roles of tie wire! I used to spend hours moving panels around. Now this lady gets it done fast without the backache. It always seems like I could use a few more. My orders have always arrived quickly. The cardboard tube they were shipped in just needed a small cut in one end to make the hinges slide out.
Joseph M from Missouri
In May I purchased 16 48" and 20 36" units to make tomato and pepper cages with 4ga cattle panel material. When I went to make the cages I discovered that the diameter was way too large (made for loose, sloppy corners). I now see that they mention that the connectors are now sized for 3/8" rods (.375") versus 4ga (.2"). So my purchase turned out to be a total waste. I would never purchase these again. In the video I guess that the old style connectors are being used (seem to fit quite nicely with regular cattle panels. I guess that I have more for the scrap heap now ($100 down the drain).
Donna P from Texas
Provides a strong, reliable connection that is also a 360º hinge. Unlike "hinges" of twine and soft wire that fail at the wrong moment, this hinge does not fail. Its so easy to use and makes fencing much easier to do. I am a 63 year old woman and was able to make my goat pen in one day thanks to these hinges.
Paul D from Indiana
Nice way to finish off ends of stock panel. I am using these to finish off the corners of my deck railing. It joins them together for a finished look.