Cut Out Switch
- 7"L x 2"W
- 4-3/4" knife
- All connections are stainless steel
- Attach with screws or nails (not included) to a location where the lever can be switched up and down. It's best to mount switch with yellow handle of lever on top. The switch is "on" when the lever is up.
- Use insulated wire designed for high voltage to run from power source to the lower of the 2 contact terminals.
- Use another piece of insulated wire to run from top contact terminals to the fence.
Screws not included.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Roger H from Iowa
Very easy to install, very visible and cost effective.
Edmund T from Texas
This switch is much better than the ones I have been purchasing from Tractor Supply and it is less expensive. I purchased 3 to replace my current switches and will be purchasing more in the future.
Patrick P from Wisconsin
Was just the device needed to make life easier on the back 20 for my wife and others to manage fence electricity without fear of shocks to change, repair and open sections of fence.
Carol M from New Mexico
Love these. If necessary to find the section of fence that might have a problem, I won't have to take the whole fence system off line to narrow down the area that needs help.
Jim J from Missouri
Good product and larger than expected. Can see the yellow handle at 150 ft. helpful when you forget if you turned it back on.