- Will work for twine, narrow tape, rope, MaxiShock and braid.
- Does not work for high-tensile wire.
- Hook ring end into a P Spring.
- Insert rope through other end and through hole on center bolt.
- Hold tail of rope to secure it and twist black knob on the side.
- Once the tail of rope is secured, let go and continue twisting knob until desired tension is reached. P Spring should be half compressed.
- To loosen or remove conductor from the tensioner: unscrew the knob on the side to release.
Write a Review
You must be logged in to leave a review. Please sign in.
Leon E from Florida
These are great - they're made of plastic, so they both tension and insulate. If you attash them to the spring you don't need another insulator. If you do want the spring to be energised - just leave a bit of the rope out and tie it to the spring, then make a loop and run the loop the tensioner, rather than the very end of the rope. Also, personally I didn't think they were difficult to tighten and I'm no athlete.
Joel C from Iowa
Fast shipping and exactly what we needed!
Jackie N from WI
I don't like these. I think the knob is hard to turn. I don't like that they are plastic. If they were metal, then you could connect the electric to the p spring. They seem well made and are not cheap, but I don't think they are necessary or convenient.
Linda H from Ohio
Wonderful. Makes tensioning rope fencing easy. I use with a P-spring at one end and a corner pulley insullator at the other end of longer runs.
Joe H from SC
This works, but is hard to use, not sure I'd buy these again, but price is right.