- Made of durable plastic that grips rod tightly
- Use with 3/8" FiberRod posts
- Holds rope, MaxiShock, twine and narrow tape
- Sold in bags of 20 but priced per clip
- Place clip at an angle on the SmoothCote FiberRod Post or Step-In FiberRods Post with the 2 open ends of clip against the post.
- With thumb and finger, push and twist at the same time. This will spread the jaws of clip and allow them to snap onto post.
- Adjust to desired height by sliding the harp clip up or down on post.
- Thread conductor through clip.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Mary G from Michigan
These were easier to put on than I had anticipated. So far they're working well.
Ellis R from New Hampshire
Once I fugured out how to snap the first one onto the post, the rest went on easily. It was easier to snap them on by hand than by using the snap-on took. They can be repositioned with a little effort, but seem to firmly hold the new position. My only complaint is that they don't hold the bottom non-conducting strand of a web fence as close to the ground as I would like.
Roger H from OR
These clips are great!! Better than anything I've used before and they just won't break, which I can't say for the ones that come attached to the fiberglass posts that I've purchased locally in the past. They are a little tricky to put on at first but once I learned to to position them with my fingers and then give a little twist, they snap right on. My wife and daughter were able to put them on, no problem, once they learned the motion. They are a little difficult to reposition but I don't mind that because I don't want my conductor slipping up and down. I reposition them for 2 or 3 strands occasionally without a problem. Highly recommended!!
Sharon H from CA
I almost did not buy these after reading Tom's review on how hard they are to put on. So I only ordered a few to begin with, and an installation tool. I do not use the tool. They seem to have the right firmness when putting on the post and sliding, although I try to put at the desired height to begin with. I have not tried to remove one, looks like it would be difficult. Twine will come out with a lot of upward pressure. In this case I used 2, one upside down.
Will D from Kentucky
I love the harp clips! They are small and clean, easy to install, and inexpensive. Because they are dynamic, I can slide them up and down the 3/8" fiberglass posts whenever adjustments to my intellitwine becomes necessary. I've used a ton of them and will continue to use them for all my strand fence needs. Great product!