- Made of durable plastic that grips rod tightly
- Use with 3/8" FiberRod posts
- Holds rope, MaxiShock, twine and narrow tape
- Sold in bags of 20 but priced per clip
- Place clip at an angle on the SmoothCote FiberRod Post or Step-In FiberRods Post with the 2 open ends of clip against the post.
- With thumb and finger, push and twist at the same time. This will spread the jaws of clip and allow them to snap onto post.
- Adjust to desired height by sliding the harp clip up or down on post.
- Thread conductor through clip.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Roger H from OR
These clips are great!! Better than anything I've used before and they just won't break, which I can't say for the ones that come attached to the fiberglass posts that I've purchased locally in the past. They are a little tricky to put on at first but once I learned to to position them with my fingers and then give a little twist, they snap right on. My wife and daughter were able to put them on, no problem, once they learned the motion. They are a little difficult to reposition but I don't mind that because I don't want my conductor slipping up and down. I reposition them for 2 or 3 strands occasionally without a problem. Highly recommended!!
Sharon H from CA
I almost did not buy these after reading Tom's review on how hard they are to put on. So I only ordered a few to begin with, and an installation tool. I do not use the tool. They seem to have the right firmness when putting on the post and sliding, although I try to put at the desired height to begin with. I have not tried to remove one, looks like it would be difficult. Twine will come out with a lot of upward pressure. In this case I used 2, one upside down.
Will D from Kentucky
I love the harp clips! They are small and clean, easy to install, and inexpensive. Because they are dynamic, I can slide them up and down the 3/8" fiberglass posts whenever adjustments to my intellitwine becomes necessary. I've used a ton of them and will continue to use them for all my strand fence needs. Great product!
Tom P from MD
I have been using your products for years and loved all of them. Thank you! And, a big thank you for such an informative catalog! Ok, but these harp clips are the only thing I have ever gotten from you that made me curse...a lot! I appreciate that you came up with something in between the wire clips and screw type (both of which I use), but these harp clips are really difficult to put on (we bent 2 tools within minutes) and they are very difficult to reposition once on the post. They do see to hold the twine very securely, and so if I was going to a long term semi-perm. fence it would be ok, but not worth the time for a fence that was only going to stay up 6 months. Luckily, we didn't order too many, because we definitely are going back to the screw-type & wire clips.