HotShock 5 Energizer
A low-cost 0.5 joule low-impedance electric fence charger which is recommended for temporary, short-length fences for sheep, goats, poultry and wildlife. Also temporary medium-length or permanent short-length fences for cattle and horses.
Includes connections to run as either a 110V plug-in or 12V battery (replacements sold separately under the accessories tab).
- For temporary, short-length fences for sheep, goats, poultry and wildlife
- For temporary, medium-length fences for cattle and horses
- For permanent, short-length fences for cattle and horses
|Energizer Only||Plug-in Kit*||Battery Kit*|
|HotShock 5 Energizer||✔||✔||✔|
|(1) Ground Rod (galvanized)||3 ft||3 ft|
|(1) Ground Rod Clamp||✔|
|(1) Hanging Nut||✔|
|MaxiShock Insulated Cable||100' roll|
|5-Light Wireless Fence Tester||✔||✔|
- 1 mile of 3 strand cattle fence
- 1/2 mile of a 5-7 strand sheep fence
- 6 rolls of 164' sheep/goat nets
- 3 rolls of 164' poultry nets
- Requires a grounding system. Inadequate grounding is the most common failure in an electric fence system. We recommend 3 ft. of grounding for this energizer.
- 12V battery draw is 46 milliampere (mA) per hour. With this energizer a 12V, 100 ampere hour deep-cycle battery will last approximately 54 days. (Assumes 40% drawn down between charges.)
- To operate as a solar energizer, run the unit as a battery unit (DC) and attach a solar panel to charge the battery. (10 watt panel recommended.)
- 0.50 released joules
- 0.50 joules in moist soils
- 0.24 joules in dry soils
- Pulses per minute: 38
- 12V DC draw: 46 mA/hr
- 110V draw is 4.5 watt per hour
- Impedance type: low – pulse type
- Input: AC/DC
- 110V plug-in adapter
- 12V battery adapter (Batteries sold separately.)
- A wiring harness is included to connect energizer to fence and energizer to ground rod.
To use the energizer as a plug-in unit:The energizer can be mounted either inside or outside of a building, but not where there is risk of fire. The energizer must be mounted vertically. Protect the energizer from direct rainfall.
- Connect an insulated cable (stripped back 1 - 2" on ends) to the fence terminal on energizer, run the cable to the fence line and connect, or use the positive part of the wiring harness.
- Then run a second length of cable from the ground terminal (with ends stripped again) on the energizer to the ground rod(s), or use the negative part of the wiring harness.
- Secure to ground rod(s) with a clamp.
- Plug the energizer directly into an outlet and test fence. Do not use an extension cord as it may cause a decrease in voltage and expose the unit to the elements.
To use the energizer as a battery unit:
- Attach wiring harness to energizer.
- Attach the bare end of the wire with the red clip to the fence terminal of the energizer. Attach the red alligator clip to the fence.
- Attach the bare end of the wire with the black clip to the ground terminal of the energizer. Attach black alligator clip to the ground rod(s).
- Connect the energizer to the battery.
- Insert battery adapter into the energizer. Attach red alligator clip from the adapter to the red “+” terminal of the battery.
- Attach black alligator clip from the adapter to the black “–” terminal of the battery.
Unit indicator light should flash and a tic-tac sound will be heard. If the indicator light doesn't flash, then the unit/battery should be checked.
To Reduce Risk & Liability
- Never place your head or upper spine near an electrified wire. Accidental head or neck contact can occur when pushing a voltage probe into the soil. Be careful when doing so to avoid head-to-wire contact!
- Never attempt to step over or climb through an energized fence of any kind.
- Never encourage anyone to touch an electric fence.
Start by measuring the voltage at the end of the fence line. If the voltage is below 3000V, follow these steps to determine if the problem is with the fence, or the energizer.
Test the energizer first!
- Turn off the energizer.
- Disconnect the wires going to the fence and ground stake/rod.
- Turn the energizer back on.
- Measure the voltage on the energizer between the two terminals (positive and negative) with a digital voltmeter or other high-voltage tester. Touch one end to “-“ (earth terminal) and the other end to “+” (fence terminal). The reading tells you how well the energizer is working without any other variables.
- If the tester reads below 5000V, then the energizer (or possibly the battery) is the problem. If the voltage is above 5000V, then the trouble lies with your fence.
If the fence is at fault:
- Conductors touching another wire, steel post or the soil
- Broken or damaged insulators
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
FencingItem #147510 -
Holds solar panels of nearly any size (10 to 80 watts) at 45˚ (for maximum solar response in most conditions) on top of the energizer/battery support box.$27.50
Energizer Solar Panels and AccessoriesItem #112002 -
Attach to Premier Intellishock and HotShock electric fence energizers to adapt them to run on battery power.$9.26
Write a Review
You must be logged in to leave a review. Please sign in.
Sue G from Virginia
We’ve had 2 HotShock 5 units in succession. Both died about 1 month after warranty expired. Trying the Patriot next but not expecting better. Seems to keep raccoons out most of the time, little effect on possums.
Jeff E from Oregon
I wouldn’t recommend the fence tester as it comes with a dead battery and is designed poorly. A struggle to fit the battery in the case.
But everything else seems to be ok.
Drake N from Delaware
Great product that has worked well. What’s even better is when I had a problem with the unit Premier backed it up and replaced it. Both the fence, energizer and poles have provided awesome protection to my flock.
Kenneth S from Michigan
Bought to keep predators out of my chickens. So far it has done it's job and had no issues.
Nate B from Pennsylvania
The bright green LED flashes when it is on, and it does not need a huge battery to run all night. My meter read 12.5 volts at night and 12.34 in the morning, with a 164' poultry net. With a good ground I read 6–7k on the fence tester. It would be nice to have a switch on it, but it is very easy to wire one into your setup.