- 1" wide
- 8.5" long without tension
- Stretches to 35 lb (half compressed)
- Stainless steel—so it won't rust
How to Use
- Attach one end of spring to a terminal insulator. (The P Spring will simply hook over some insulators; for others, you will need to tie the spring to insulators with rope or wire.)
- Attach conductor to other end of spring by taking the loose end of conductor and putting it through open end of spring.
- Pull conductor until spring is 1/3 to 1/2 compressed.
- Run conductor through the loop one more time and tie off.
- Whenever conductor becomes loose, repeat above steps.
However, if you don't have a helper to hold the tension on the rope, you may lose too much tension in the process of getting the RopeLink wrapped around the rope.
Solution: Attach the P Spring to the terminal insulator and loop the rope through it twice. Then pull the rope tight so the P Spring is FULLY compressed. When you get the RopeLink attached, you may have lost some of the tension on the rope, but the P Spring is half compressed just like it should be.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Darlene B from Montana
I love these springs, makes putting up a fence so much easier.
Gail G from Michigan
This is an excellent way to attach ropes to posts . You don't have to have arms of steel to make the ropes as tight as you want.
David H from Houston Texas
I was amazed at how fast my order arrived, and the P Spring is perfect for my driveway sail. BRAVO!
Justin S from Vermont
I use these springs with 4.5mm rope and they work great. Keep the line nice and taut and are easy to attach to insulators.
Richard P from Kentucky
These springs work great for keeping tension on 14ga electric wire. Use a 1/8” wire rope (cable) thimble to attach wire to spring. It keeps the kink out of wire.
I run a smooth wire about 1” below bottom board of my 4 board fence and another between two bottom boards. This keeps dogs and coyotes from crossing fence.
Using tube type insulators behind the trim board on each post makes the wire almost invisible from a distance. Does not detract from the look of a board fence.