SnapOn Harp Clip Tool
It's much faster and easier on your fingers to use this simple tool to install SnapOn Harp Clips to FiberRod Posts.
Specs
- 2.25"L x 1.75"W
- Zinc plated
Installation
- After the SmoothCote FiberRod Post or Step-In FiberRod Post are in the ground, use the SnapOn Harp Clip Tool to install the SnapOn Harp Clips.
- Hold jaws of harp clip at an angle against the rod. With tool in other hand, place the C-shaped opening of tool onto top and bottom jaws of clip.
- Twist the tool to force harp clip to snap onto rod. It will snap on both ends at the same time.
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
-
Insulators
SnapOn Harp Clip, 3/8", each
Item #325310 -For attaching conductors at desired height on 3/8" fiberglass posts. Design allows conductors in but prevents their escape.
$0.24 -
Posts and Accessories
SmoothCote™ FiberRods, 3 ft. (3/8 in. dia)
Item #321831 -Lightweight fiberglass posts for use with livestock containment fence or deer deterrent fence.
$1.40
Write a Review
You must be logged in to leave a review. Please sign in.
Lawrence K from Wisconsin
They recommend having these and they're right... my hands are no longer strong enough. It takes a while to learn how to use it to the best advantage.
Ellis R from New Hampshire
It was easier to snap the harp clip on and off by hand than by using this tool. Don't waste your money on it.