TuffRing™ II Power Driver
- 1-3/4"L x 3/4"W
- Galvanized steel
How to Use
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
Write a Review
You must be logged in to leave a review. Please sign in.
Bruce D from New Hampshire
Good idea, but it breaks at the base. Not a bad weld, but weak material for the stem. We’ve managed to re-weld most of ours, and it is a pain, but seems to work. Just be careful re-welding galvanized steel.
Nicole G from West Virginia
The first one broke after I tried to drive an earth anchor into the ground (after using it for many tough rings). The weld broke. It shouldn't have broken as there didn't seem to be a lot of torque with what I was driving.
The second one broke after 2 tough ring ii's into treated wood posts. It just sheared off.
George K from New York
Broke after the third one.
Lavern S from Pennsylvania
A great tool for installation of the Tuff Ring insulators. Can't imagine trying to install very many without this tool. I did paint one end so as I screw them in I can tell what end is up. Makes installation quicker.
Stephen H from Texas
A must have when using the tough grip insulators. It makes installing them a breeze. We put a mark on one of the ends of the power driver and always put the top part of the tough grip insulator in the driver where the mark is. That way after you get it screwed in all the way, you know where the top is, so you know where to stop. It would be a bit easier to use if it had a little tighter fit for the tough grip insulator to fit inside, but you learn and adjust and all is well. We work outside as a family with our 7 young children and they like to take turns and help install them. Thank you premier for your great products!