IntelliShock 10 Energizer
This 1 joule unit automatically adjusts battery draw down by as much as 67% if the fence isn’t touching green weeds or shorted out (e.g. 1 or 2 strand horse, cattle, anti-deer fences; also most fences during the winter or when grass is dormant). The need to recharge a battery is therefore much less in these seasons or situations.
Includes connections to run as either a 110V plug-in or 12V battery (replacements sold separately under the accessories tab).
|Energizer Only||Plug-in Kit*||Battery Kit*|
|IntelliShock 10 Energizer||✔||✔||✔|
|(1) Ground Rod (galvanized)||3 ft||3 ft|
|(1) Ground Rod Clamp||✔|
|(1) Hanging Nut||✔|
|MaxiShock Insulated Cable||100' roll|
|Digital Tester for Fences & Batteries||✔||✔|
- 2 miles of 3 strand cattle fence
- 3/4 mile of a 5-7 strand sheep fence
- 10 of the 164' sheep/goat nets
- 4-5 of the 164' poultry nets
- Requires a grounding system. Inadequate grounding is the most common failure in an electric fence system. We recommend 3 ft. of grounding for this energizer.
- 12V battery draw is 31-90 milliampere (mA) per hour. With this energizer a 12V, 100 ampere hour deep-cycle battery will last approximately 27 (on a weedy fence) and 80 (on a clean fence) days. (Assumes 40% drawn down between charges.)
- To operate as a solar energizer, run the unit as a battery unit (DC) and attach a solar panel to charge the battery. (10 watt panel recommended.)
- 1.00 released joules
- 1.00 joules in moist soils
- 0.32 joules in dry soils
- Pulses per minute: 38
- 12V DC draw: 31-90 mA/hr
- 110V draw is 4.5 watt per hour
- Impedance type: low – pulse type
- Load sensing/variable draw: yes
- Input: AC/DC
- 110V plug-in adapter
- 12V battery adapter (Batteries sold separately.)
- A wiring harness is included to connect energizer to fence and energizer to ground rod.
To use the energizer as a plug-in unit:The energizer can be mounted either inside or outside of a building, but not where there is risk of fire. The energizer must be mounted vertically. Protect the energizer from direct rainfall.
- Connect an insulated cable (stripped back 1 - 2" on ends) to the fence terminal on energizer, run the cable to the fence line and connect, or use the positive part of the wiring harness.
- Then run a second length of cable from the ground terminal (with ends stripped again) on the energizer to the ground rod(s), or use the negative part of the wiring harness.
- Secure to ground rod(s) with a clamp.
- Plug the energizer directly into an outlet and test fence. Do not use an extension cord as it may cause a decrease in voltage and expose the unit to the elements.
To use the energizer as a battery unit:
- Attach wiring harness to energizer.
- Attach the bare end of the wire with the red clip to the fence terminal of the energizer. Attach the red alligator clip to the fence.
- Attach the bare end of the wire with the black clip to the ground terminal of the energizer. Attach black alligator clip to the ground rod(s).
- Connect the energizer to the battery.
- Insert battery adapter into the energizer. Attach red alligator clip from the adapter to the red “+” terminal of the battery.
- Attach black alligator clip from the adapter to the black “–” terminal of the battery.
Unit indicator light should flash and a tic-tac sound will be heard. If the indicator light doesn't flash, then the unit/battery should be checked.
To Reduce Risk & Liability
- Never place your head or upper spine near an electrified wire. Accidental head or neck contact can occur when pushing a voltage probe into the soil. Be careful when doing so to avoid head-to-wire contact!
- Never attempt to step over or climb through an energized fence of any kind.
- Never encourage anyone to touch an electric fence.
Start by measuring the voltage at the end of the fence line. If the voltage is below 3000V, follow these steps to determine if the problem is with the fence, or the energizer.
Test the energizer first!
- Turn off the energizer.
- Disconnect the wires going to the fence and ground stake/rod.
- Turn the energizer back on.
- Measure the voltage on the energizer between the two terminals (positive and negative) with a digital voltmeter or other high-voltage tester. Touch one end to “-“ (earth terminal) and the other end to “+” (fence terminal). The reading tells you how well the energizer is working without any other variables.
- If the tester reads below 5000V, then the energizer (or possibly the battery) is the problem. If the voltage is above 5000V, then the trouble lies with your fence.
If the fence is at fault:
- Conductors touching another wire, steel post or the soil
- Broken or damaged insulators
Listed below are recommended optional components or related items. Your particular situation may require alternative recommendations. Please call and talk to our consultants if there are any questions at 800-282-6631.
FencingItem #147510 -
Holds solar panels of nearly any size (10 to 80 watts) at 45˚ (for maximum solar response in most conditions) on top of the energizer/battery support box.$27.50
Energizer Solar Panels and AccessoriesItem #112002 -
Attach to Premier Intellishock and HotShock electric fence energizers to adapt them to run on battery power.$9.26
Write a Review
You must be logged in to leave a review. Please sign in.
Carl R from West Virginia
Works great for me. Lights up all the lights on the tester when the fence is put up and off the ground. I did have to make extra posts to get sag out of netting but expected that. But that was easier than trying to find enough level ground in good old WV.
Vernon S from Ohio
Great product at a great price. Love the upgrade to LED green lights! Very bright and easy to see from a long distance!
Tim S from North Carolina
I like the fault feature. If there are sticks, leaves, grass that is grounding the fence out the light will blink red. Remove the “object” and the light will return to green. That also means more charge can get to your animal and zap them. The unit is plenty big enough (zapping power) for one 164 foot fence. I can expand more fences if needed.
Joshua D from Missouri
The first one they sent out in a kit wasn't working correctly. No shock at the fence. The professionals at Premier 1 walked me through the troubleshooting process and agreed that it must be a bad energizer. They shipped me a new one out. (I had to pay for it but was refunded when I sent back the bad one.) No issues and it works great. Customer service is A+.
Stephen B from Connecticut
Bought this to replace an energizer that I thought was dead. When connected, it produced only a feeble 1,000 on my voltage meter, so I decided there must be a problem in the electrical line from barn to garden (about 1500 ft). Then discovered that the previous energizer just needed a fuse replacement. So I tested it again--and the voltage soared to the maximum of 5,000. So I'd have to describe the IntelliShock 10 as underpowered, to say the least.